GEAR DOORS INOP WILL NOT RETRACT AFTER AECM TEST WITH OR WITHOUT POWER INTERUPT

A350 Procedures To Reset Fault or Faults
Normal AC Power APU OR EXTERNAL.

FAULT CONDITIONS:
GEAR DOORS INOP WILL NOT RETRACT AFTER AECM TEST WITH OR WITHOUT POWER INTERUPT.

SOLUTION:
Normal AC Power APU OR EXTERNAL. PLACE LG GRAVITY SW IN RESET FOR 6 MINS THEN TO OFF. THEN RESET LGERS 1 AND 2 ON OVERHEAD AND CLOSE THE DOORS.

AECM PANEL:lift Cover/Rotate Red Tabs/Move lever SW to Reset

RESET PANEL LH:

RESET PANEL RH:

Circuit breakers or SSPC to reset:INSERT

OMT SYSTEM REPORT TESTS:
Insert Here

Fault Detected By:
N/A

Fault Code:
N/A

Results of power up test or reset:
Pass: N/A.

Fail: N/A.

Additional Notes:
The AECM: After a 5 minute delay (to allow for Actuator replenishment), energises the Vent Valve baulk solenoid through internal Hi and Lo side switching which releases the latch and allows the Vent Valve to return to its Normal position 0.5 second after the Vent Valve is reset the electrical supply is restored to the IVs, thus reconnecting the Normal hydraulic supply. The delay ensures the Vent Valve is in the neutral position and the hydraulic system has stabilised before full pressure is applied.

Manual Reference
AMM A350.

TSM A350-A-32-31-XX-4J001-421A-A.

Applicable deferrals:
MEL.

CDL.